wget http://downloads.asterisk.org/pub/telephony/certified-asterisk/certified-asterisk-1.8.11-current.tar.gz tar -zxvf certified-asterisk-1.8.11-current.tar.gz apt-get install gcc g++ make libncurses5-dev libxml2-dev tar -zxvf certified-asterisk-1.8.11-cert9 ./configure make menuselect make +--------- Asterisk Build Complete ---------+ + Asterisk has successfully been built, and + + can be installed by running: + + + + make install + +-------------------------------------------+ make install +---- Asterisk Installation Complete -------+ + + + YOU MUST READ THE SECURITY DOCUMENT + + + + Asterisk has successfully been installed. + + If you would like to install the sample + + configuration files (overwriting any + + existing config files), run: + + + + make samples + + + +----------------- or ---------------------+ + + + You can go ahead and install the asterisk + + program documentation now or later run: + + + + make progdocs + + + + **Note** This requires that you have + + doxygen installed on your local system + +-------------------------------------------+ make config make install-logrotate root@pbx:~/certified-asterisk-1.8.11-cert9# /etc/init.d/asterisk status asterisk is not running ... failed! root@pbx:~/certified-asterisk-1.8.11-cert9# /etc/init.d/asterisk start Starting Asterisk PBX: asterisk. root@pbx:~/certified-asterisk-1.8.11-cert9# /etc/init.d/asterisk status asterisk is running.