Staticke adresy jsou ulozene v address-table a v running-configu (lze je tedy ulozit)

Switch(config)# interface fastethernet 0/0
Switch(config-if)# switchport mode access
Switch(config-if)# switchport port-security mac-address [mac-address]

Dynamicke adresy si switch zjisti sam, adresy jsou ulozene jen v address-table, po restartu switche nebo spadnuti portu se vsak smazou

Switch(config)# interface fastethernet 0/0
Switch(config-if)# switchport mode access
Switch(config-if)# switchport port-security

To same jako Dynamic, jen jsou zaroven v running-configu, lze je tedy ulozit

Switch(config)# interface fastethernet 0/0
Switch(config-if)# switchport mode access
Switch(config-if)# switchport port-security maximum 50
Switch(config-if)# switchport port-security mac-address sticky

Switch# show port security interface fastethernet 0/0
Switch# show port security address

Switch# clear port-security sticky interface [port-number] access

nebo

Switch# clear port-security dynamic [address mac-addr | interface type mod/num]

Switch(config-if)# shutdown
Switch(config-if)# no shutdown

nebo

Switch(config-if)# no switchport port-security
Switch(config-if)# switchport port-security

nebo

Switch# reload

• Switch(config-if)# switchport port-security violation {shutdown | restrict | protect}

• shutdown - port okamžitě přejde do Errdisable stavu, nahozen musí být ručně nebo pomocí Errdisable recovery
• restrict - port zůstane up, rámce s nepovolenou MAC jsou zahazovány a počítá je counter, může být odeslána SNMP/Syslog zpráva
• protect - port zůstane up, nepovolené rámce jsou zahazovány, nic se nezaznamenává

Příklad Syslog zprávy:

Jun  3 17:18:41.888 EDT: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation
  occurred, caused by MAC address 0000.5e00.0101 on port GigabitEthernet0/11.

Příklad Syslog zprávy v režimu security violation shutdown:

Jun  3 17:14:19.018 EDT: %PM-4-ERR_DISABLE: psecure-violation error detected on
  Gi0/11, putting Gi0/11 in err-disable state
Jun  3 17:14:19.022 EDT: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation
  occurred, caused by MAC address 0003.a089.efc5 on port GigabitEthernet0/11.
Jun  3 17:14:20.022 EDT: %LINEPROTO-5-UPDOWN: Line protocol on Interface Gigabit
  Ethernet0/11, changed state to down
Jun  3 17:14:21.023 EDT: %LINK-3-UPDOWN: Interface GigabitEthernet0/11, changed
  state   to down

Switch# show port-security interface gigabitethernet 0/11

Switch# show port-security interface gigabitethernet 0/11
Port Security                : Enabled
Port Status                  : Secure-shutdown
Violation Mode               : Shutdown
Aging Time                   : 0 mins
Aging Type                   : Absolute
SecureStatic Address Aging   : Disabled
Maximum MAC Addresses        : 1
Total MAC Addresses          : 0
Configured MAC Addresses     : 0
Sticky MAC Addresses         : 0
Last Source Address          : 0003.a089.efc5
Security Violation Count     : 1
Switch#

Switch# show interfaces status err-disabled

Switch# show interfaces status err-disabled
Port       Name                 Status       Reason
Gi0/11    Test port            err-disabled psecure-violation
Switch#
TIP
When a port is moved to the errdisable state, you must either manually cycle it
or configure the switch to automatically re-enable ports after a prescribed delay.
To manually cycle a port and return it to service, use the following commands:
Switch(config)# interface Gi 0/11
Switch(config-if)# shutdown
Switch(config-if)# no shutdown

Switch# show port-security

Switch# show port-security
Secure Port  MaxSecureAddr   CurrentAddr  SecurityViolation  Security Action
                  (Count)        (Count)           (Count)
---------------------------------------------------------------------------
     Gi0/11                5             1                    0          Restrict
     Gi0/12                1             0                    0          Shutdown
---------------------------------------------------------------------------
Total Addresses in System (excluding one mac per port)      : 0
Max Addresses limit in System (excluding one mac per port) : 6176
Switch#